Digiplex EVO641R Instrukcja Instalacji Pobierz pdf (Strona 39)

Modules Programming Guide - 39

Module Connection Drawings

Module LED Indications

Green LOCATE LED (sometimes seen as LOC or LC):

Power Up: Remains illuminated during power up.

Locate: If the LED flashes fast during normal operation, it is receiving a

“locate” request from the control panel. Depending on the module, the

“locate” request can be disabled by pressing on the tamper switch or on

the “Disable Locate” switch.

Red WATCHDOG LED (sometimes seen as WDG, WTDG or WD):

Status: Flashes to indicate proper operation.

Communication Failure:

If both the LOCATE and WATCHDOG LEDs are alternately flashing, the

module is experiencing a communication failure with the control panel.

Green BATT LED (DGP2-ACM1P and DGP2-PS17 only):

Charging and battery test LED (every 60 seconds).

Green RX LED (MG-RTX3 only):

Flashing: The printer module is transmitting data through the serial port.

Green PULSE LED (APR-ADM2 only):

Will illuminate whenever the APR3-ADM2 is using its dialer. The PULSE

LED will remain illuminated for the whole duration that the dialer is being

used.

Remove AC and battery power from the control panel before

connecting the module to the combus.

Refer to the appropriate control panel’s Reference & Installation

Manual for the maximum allowable installation distance from the

control panel.

Any device such as a garage

door, light or siren.

External Power

Supply

PGM 5A

Relay

Figure 2: Connecting a 5A PGM Output

Some modules’ PGM output(s) are comprised of

one or more 5A relays. Connect the PGM output as

shown below. For the external power supply, we

recommend the DGP2-PS17 Power Supply Module.

Figure 3: Connecting a 50mA PGM Output

Some modules’ PGM output is comprised of one 50mA

output. Connect the PGM output as shown below.

Figure 1: Connecting the Combus

Digiplex control panel

(EVO48 & EVO192)

Combus

Module

Open Collector

(Negative Trigger)

12 Vdc 50 mA

To drive more than

50mA

use a 12Vdc relay

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 59 60

Komentarze do niniejszej Instrukcji

Brak uwag

Digiplex EVO641R Instrukcja Instalacji Strona 39

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Digiplex EVO641R