Digiplex EVO641R Instrukcja Instalacji Pobierz pdf (Strona 14)

14 - Modules Programming Guide

DG85 V1.3

Outdoor High-Security Digital Motion Detector Modules

Operational Modes

The DG85 can function in two different operational modes: combus mode or relay mode. This option can only be configured using the J3

jumper:

Relay Mode: (DIP Switch 1 = OFF)

When set to Relay Mode, the DG85 functions as would any standard motion detector by communicating its alarm and tamper signals

via relays. The GRN and YEL terminals are not used in relay mode. In Relay Mode, the detector’s settings can only be modified using

the jumpers see table below.

Combus Mode: (DIP Switch 1= ON)

When set to combus mode, the DG85 communicates alarm signals, tamper signals, data and detector settings via the panel’s 4-wire

combus. The detector’s relay output always remains active even when set to combus mode and can be used to activate other

devices.

Settings

Refer to DG85’s connection drawing on page 42 for the location of the DIP switches and Trimpot.

To set the sensitivity manually, remove the front cover and, using a screwdriver, turn the trimpot clockwise to increase the detector’s

sensitivity or counter-clockwise to decrease it. You can turn the trimpot 360° in both directions. To determine the sensitivity setting, remove

the cover and view how many times the LED flashes. The number of times the LED flashes corresponds to the sensitivity setting. Thus if the

sensitivity is set to 6, the LED will flash 6 times

In instances where a particular setting can be set either manually or through section programming, a discrepancy may exist between the

setting of the DIP switches and the setting in the appropriate sections. In such cases, the last change that is made will dictate the setting.

For example, if you disable the LED from within section programming, the DIP switch will still show that it is enabled, however the LED is

actually disabled.

U = Default Setting

Section [001] General Options

Options OFF ON Manual Setting

[1]

Single/Dual Edge Processing

N Dual Edge U Single Edge

DIP Switch 2

OFF = Dual Edge

ON = Single Edge

[2]

LED

N Disabled U Enabled DIP Switch 3

OFF = Disabled

ON = Enabled

[3]

Movement Signal Indication

N Disabled U Enabled Enabled when DIP Switch 3 is ON

[4]

Future Use

NN/A NN/A NN/A

[5]

Tamper Recognition

U Disabled N Enabled NN/A

Section Data Description Default

[002] __/__/__ 000 Lowest Sensitivity, 010 Highest Sensitivity

Trimpot 0-10

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Komentarze do niniejszej Instrukcji

Brak uwag

Digiplex EVO641R Instrukcja Instalacji Strona 14

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Digiplex EVO641R