Digiplex DGP2-641BL Instrukcja Instalacji Pobierz pdf (Strona 30)

30 - Digiplex Modules Programming Guide

Module Connection Drawings

Module Connection Overview

Module LED Indications

Green LOCATE LED (sometimes seen as LOC or LC):

Power Up: Remains illuminated during power up.

Locate: If the LED flashes fast during normal operation, it is receiving a “locate”

request from the control panel. Depending on the module, the “locate” request can

be disabled by pressing on the tamper switch or on the “Disable Locate” switch.

Red WATCHDOG LED (sometimes seen as WDG, WTDG or WD):

Status: Flashes to indicate proper operation.

Communication Failure:

If both the LOCATE and WATCHDOG LEDs are alternately flashing, the module is

experiencing a communication failure with the control panel.

Green BATT LED (DGP2-ACM1P and DGP2-PS17 only):

Charging and battery test LED (every 60 seconds).

Green RX LED (MG-RCV3 only):

Flashing: The printer module is transmitting data through the serial port.

Green PULSE LED (APR-ADM2 only):

Will illuminate whenever the APR3-ADM2 is using its dialer. The PULSE LED will

remain illuminated for the whole duration that the dialer is being used.

General Warnings

Remove AC and battery power from the control panel before

connecting the module to the combus.

Refer to the appropriate control panel’s Reference & Installation

Manual for the maximum allowable installation distance from the

control panel.

Any device such as a garage

door, light or siren.

External Power

Supply

PGM

Relay

Figure 2: Connecting a 5A PGM Output

Some modules’ PGM output(s) are comprised of one or

more 5A relays. Connect the PGM output as shown below.

For the external power supply, we recommend the DGP2-

PS17 Power Supply Module.

Figure 3: Connecting a 50mA PGM Output

Some modules’ PGM output is comprised of one 50mA output.

Connect the PGM output as shown below.

Figure 1: Connecting the Combus

Digiplex control panel

(DGP-848/DGP-NE96)

Combus

Module

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Komentarze do niniejszej Instrukcji

Brak uwag

Digiplex DGP2-641BL Instrukcja Instalacji Strona 30

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Digiplex DGP2-641BL