Digiplex DGP-641 Dokumentacja Pobierz pdf (Strona 7)

6 Installer’s Guide

3.0 PROGRAMMING

Programming the DGP-641 LCD keypad is simple. Enter the "Module

Programming Mode", enter the desired section followed by the required

data as shown in Figure 3-1. When programming the keypad, use the

DGP-641 LCD Keypad Programming Guide to keep track of which

sections were programmed and how. We strongly recommend you read

this entire manual before you begin programming.

The LCD keypad can also be programmed using the WinLoad Security

System Management Software. For more information, refer to the

WinLoad instructions or visit our web site at www.paradox.ca.

3.1 ENTER MODULE PROGRAMMING MODE

The keypad, like all other modules in the Digiplex system, is

programmed through the control panel. To do so, you must first enter

the "Module Programming Mode" (see Figure 3-1).

The control panel will then redirect all programming to the selected

keypad. Every time the [CLEAR] key is pressed it will revert to the

preceeding step, unless entering in data in which case it will erase

the current data entry. Please note that the serial number is located

on the keypad's PC board or enter section [000] in Step 3 from

Figure 3-1 to view the keypad’s serial number.

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Brak uwag

Digiplex DGP-641 Dokumentacja Strona 7